| Title | Rating | Reads |
Alternator removal How to remove your alternator. Yours may be in a different location, but the process is similar for all of them. Contributed By: Sparky on Wednesday, November 12 | (0 votes) | 373 |
Broken clutch cable stop on pedal cluster repair Has your clutch pedal fallen to the floor, but your cable is still in tact? The problem is a broken stop at the top of your pedal cluster. Click here to solve this problem Contributed By: Sparky on Monday, November 17 | (0 votes) | 265 |
Changing the heater blower How-To: Change the heater blower on a non-A/C Caddy. Contributed By: Lucky on Thursday, October 16 | (0 votes) | 276 |
CIS: Cold Start / Rough Idle Trouble shoot your cold start issues. Contributed By: Lucky on Saturday, May 03 | * * * * * (1 votes) | 750 |
Cleaning Your MAF Sensor Step by step instructions. Contributed By: Lucky on Saturday, May 03 | (0 votes) | 384 |
DigiFant, Single Fuel Pump Conversion Alternative to the 2-pump set up in Digifant Mk1s. Write up courtesy of Ron, of Mk1Dubs.com. Contributed By: Lucky on Saturday, December 20 | (0 votes) | 321 |
Dynamic oil pressure system and operation Dynamic Oil Pressure Warning System Operation and Testing. Contributed By: Sparky on Saturday, May 24 | * * * * * (1 votes) | 293 |
Flaring brake and fuel lines How to flare steel brake lines, the process is the same for fuel lines, only larger. Contributed By: Sparky on Thursday, May 29 | (0 votes) | 220 |
Greasing door latches How the grease the internals of your Mk1s door latches. Covers door latch removal. Contributed By: Sparky on Thursday, November 06 | (0 votes) | 244 |
How to convert your air conditioning system Converting the Mk1's AC from R12 to R134A Contributed By: Sparky on Saturday, November 08 | (0 votes) | 384 |
How-To: Air / fuel adjustment on the CIS system Adjusting the air / fuel mixture on a mk1 Volkswagen with CIS
Write up courtesy of Oran Sands, of http://merlyyn.com/ Contributed By: Sparky on Friday, May 23 | * * * * * (1 votes) | 562 |
How-To: Clutch cable replacement for all Mk1s A tutorial describing the process of removing and replacing the clutch cable for all Mk1s with manual transmissions. Contributed By: Sparky on Tuesday, May 20 | (0 votes) | 320 |
How-To: Mk1 rear shock replacment A tutorial explaining the removal and installation of the rear shocks on a Mk1 Volkswagen. Contributed By: Sparky on Friday, May 23 | (0 votes) | 337 |
How-To: Replacing wheel bearings without removing the housing from the car A tutorial explaining the removal and installation of the front wheel bearings on a Mk1 Volkswagen without removing the housing from the car.
Write up courtesy of of Ron, of www.vwvortex.com & www.Mk1Dubs.com Contributed By: Sparky on Friday, May 23 | (0 votes) | 485 |
How-To: Swap a Mk1 automatic transmission to manual A tutorial explaining the process of swapping from an automatic to manual transmission in a mk1 Volkswagen.
Write up courtesy of Moljinar of www.vwvortex.com Contributed By: Sparky on Thursday, May 22 | (0 votes) | 358 |
Ignition cylinder replacment How to access and replace your ignition cylinder Contributed By: Sparky on Tuesday, November 11 | (0 votes) | 239 |
Installing an aftermarket oil cooler Upgrading Volkswagens stock oil cooler
Tutorial courtesy of Briano, of www.Mk1Dubs.com Contributed By: Sparky on Saturday, May 17 | (0 votes) | 278 |
Spun Crank Gear fix Crank gears can become loose over time. Replacing a crank is both time consuming and expensive. sdezego, of VWVortex.com shows us a cheaper alternative. This write up also covers removal of a broken crank bolt. Contributed By: Sparky on Monday, November 17 | (0 votes) | 224 |
Vacuum Distrubutor Diagram Legoguy disassembled the vacuum distributor in his Mk1 Cabriolet and discovered that the diagram Bentley manual was incorrect. He then drew up his own diagram. This will be helpful for those of you that own Mk1s equipped with air conditioning.
Write up courtesy of Legoguy, of www.VWVortex.com Contributed By: Sparky on Saturday, May 24 | (0 votes) | 532 |