| Title | Rating | Reads |
020 5th gear removal and installation
Broke's write-up showing the removal of 5th gear from an 020 Including Ron's in-car method. Including measurements for the 5th gear fork tool.
Contributed By: Sparky on Thursday, October 30 | * * * * * (1 votes) | 1806 |
020 Drive shaft CV flange removal and installation
removing and reinstalling the flanges on an 020 transmission
Contributed By: Sparky on Thursday, May 29 | (0 votes) | 3122 |
020 Reverse switch wiring
A tutorial explaining how to make your reverse lights work again after a transmission swap.
Contributed By: Sparky on Monday, May 26 | (0 votes) | 1195 |
020 Tranny information and specs from BrokeVW
Gear ratios explained, specifications, speedometer gears, mounts, etc.
Contributed By: Sparky on Sunday, May 25 | (0 votes) | 2137 |
020 trans 5th gear damage warning
An example of a transmission that was run low on oil. The fifth gear is damaged and needs replacement.
Contributed By: Sparky on Sunday, May 25 | (0 votes) | 937 |
020 Trans mounts Mk1 VS Mk2
Mk1 and Mk2 020 transmissions and the difference in mounting points for the trans mounts, front and rear.
Contributed By: Sparky on Sunday, May 25 | (0 votes) | 1134 |
020 Transmission Codes and Specs
Transmission details.
Contributed By: Lucky on Saturday, May 03 | (0 votes) | 15372 |
Adjusting the 5th gear detent bolt in an 020 trans
The plastic knob on top of your trans adjusts the tension needed to shift into fifth gear. This tutorial explains how to remove, reinstall and adjust it.
Contributed By: Sparky on Thursday, May 29 | (0 votes) | 1238 |
Changing the gear oil in your 020 trans.
How to change your gear oil.
Contributed By: Sparky on Monday, May 12 | (0 votes) | 1397 |
Clutch operating lever check AKA release arm
Checking the clutch operating lever will tell you if the clutch release bearing or actuation finger need to be replaced.
Contributed By: Sparky on Thursday, May 29 | (0 votes) | 1372 |
How to keep the pressure plate from spinning while breaking the bolts loose or torquing them down.
The wrench trick to hold the pressure plate in place while torquing the bolts down, or breaking them loose.
Contributed By: Sparky on Thursday, May 29 | * * * * * (1 votes) | 846 |
How to make your own 27mm allen / hex tool to remove the selector cover and timing hole plug in the trans
The green plug in the timing hole in the bell housing and the selector cover are a 27mm hex / allen key.
The correct tool can be expensive and difficult to find, here are some other options
Contributed By: Sparky on Friday, May 30 | (0 votes) | 1270 |
How-To: 020 Tranny 5th gear swap
Fifth gear swap in a Mk1 020 transmission. Installing a taller 5th. Removing the 5th gear housing from the trans case.
Contributed By: Sparky on Sunday, May 25 | * * * * * (1 votes) | 1244 |
How-To: 020 Transmission tear down.
A tutorial explaining the process of taking the 020 transmission apart.
Contributed By: Sparky on Sunday, May 25 | (0 votes) | 1922 |
How-To: Rebuild a diff and install a bolt kit
Differential rebuild, installing a bolt kit, drilling out and replacing rivets with bolts in an 020 transmission
Contributed By: Sparky on Sunday, May 25 | * * * * * (1 votes) | 1142 |
How-To: Rebuilding an 020 trans
A tutorial explaining the process of rebuilding an 020 transmission. Trans rebuild.
Contributed By: Sparky on Sunday, May 25 | (0 votes) | 954 |
How-To: replace the torque converter seal in an 010 automatic trans
A detailed description documenting the replacement of the torque converter seal in an 010 automatic transmission.
Tutorial courtesy of Briano, of Mk1Dubs.com
Contributed By: Sparky on Friday, May 16 | (0 votes) | 1015 |
Inspecting an Option6 6 speed trans
Disassembling and inspecting the frightening, hacked-together mess that is the Option6 six speed transmission.
Contributed By: Sparky on Thursday, May 29 | (0 votes) | 793 |
Peloquin LSD diff test
Testing a Peloquin brand limited slip, shim kit differential at 20% 40% and 80%
Contributed By: Sparky on Monday, May 26 | (0 votes) | 858 |
Replacing the pushrod seal and bushing in an 020 trans
Bushing and oil seal replacement in an 020 transmission.
Contributed By: Sparky on Thursday, May 29 | (0 votes) | 1132 |
Replacing the throw out bearing
How to: Replacing the clutch release, or throw -out bearing.
Contributed By: Sparky on Tuesday, May 13 | (0 votes) | 1568 |
Transmission 5th Gear Conversion
How to swap your 5th gear.
Contributed By: Lucky on Friday, May 02 | (0 votes) | 1190 |
Troubleshooting Your Automatic Transmission
Troubleshooting and parts wear comparison for automatic transmissions on Rabbit, Scirocco, Dasher, Type 2, Audi 100 LS and Audi Fox.
Contributed By: Lucky on Tuesday, March 10 | (0 votes) | 876 |
Updates: 
FAQ and Information 
Tutorials & How-To's 
Technical Data 
Mk1 OEM Paint Codes 
Etcetera 
Recalls & Defects 
Links 
